What is standard installation?
Standard installation of a wall split system includes the following features:
- The length of the route between the blocks of the split system is no more than 5 meters;
- Inter-unit communications indoors (from the indoor unit of the air conditioner to the hole in external wall) are covered with decorative plastic box(without gating routes);
- The external air conditioner unit is installed under the window using standard brackets;
- Electrical power is supplied “to the outlet”;
- The drainage goes outside.
Installation is possible with free access to the section of the wall of the room where the indoor unit air conditioner
In addition, it is necessary to be able to fully open the window through which the outdoor unit is planned to be installed. U
install external unit from 5.5 kW of power at a height of three meters is only allowed
with the participation of an industrial climber, whose services are not included in the cost of installing the air conditioner.
With more detailed information about the cost installation work You can check it out.
Russian thermal curtains from Teplomash appeared on the market several years later than Tropic equipment, but are in good demand due to reasonable prices. pricing policy, thoughtful design and good...
The thermal curtain of the Teplomash 300 E KEV 6P-3050 E brand is intended for installation above openings whose height is in the range of 2-3.5 m. The equipment shows effectiveness when used in shops, offices, small warehouses, public and cultural premises.
The device generates a dense air flow that prevents the penetration of street cold and dust, maintaining a comfortable microclimate inside the facility. The use of Teplomash 300 E KEV 6P-3050 E curtains provides significant savings on costs.
Functional Features
- electric heating element;
- economical energy consumption;
- universal installation- horizontally above the opening, vertically on the side of the doors;
- low noise level;
- remote control with a monitor for displaying indicators. Several air curtains can be connected to one remote control for simultaneous control of power, fan speed, and heating temperature of the blown air;
- powerful fan;
- mounting brackets included;
- three operating modes: on full power, by 50%, without heating, which allows you to use the curtain as a fan in the summer season.
Teplomash 300 E KEV 6P-3050 E has a durable body made of sheet steel with stainless properties, polymer coating, protecting against corrosion. The device is reliable, equipped with protection against overheating and voltage problems. The curtain minimizes heat loss in the winter season and maintains a comfortable microclimate in hot weather when operating as a fan.
Air-thermal curtains “Comfort” of mixing type KEV-9P3011E, hereinafter referred to as “curtains”, are designed to protect an open opening (door) with a height of 2 to 2.5 meters from the penetration of cold outside air into the building by mixing cold air with a heated flow from the curtain.
The curtains are installed both horizontally above the opening and vertically on the side of the opening in vestibules and vestibules. Recommendations on the selection of a curtain, its thermal power and location in relation to the opening, depending on the outside temperature, the number of floors in the building (building height), the type of doors, the number of people passing through the doors per hour, should be given by a heating design specialist and ventilation.
The curtains are not intended to protect openings in car washes and other premises where there is droplet moisture or fog in the air. Curtains of version E have an electric heat source and are designed for operation in both periodic and continuous modes. When opened relatively rarely, doors can be used as an additional source of heat in rooms.
Working conditionsAir-thermal curtains KEV-9P3011E series “Comfort 300”
Scope of applicationThermal curtains of the KEV-9P3011E series are designed to protect openings with a height of 2.0m to 3.5m in office, retail, warehouses, as well as in buildings for cultural and domestic purposes.
AutomationThermal curtains KEV-9P3011E are controlled from a remote or remote control panel. Inside the remote control there is an ambient temperature sensor and a thermostat. The degree of protection of the remote control shell is IP20.
The remote control is a receiving device for the infrared signal from the remote control. The remote control contains: five buttons, five LEDs, an infrared signal receiver and an LCD display. The remote control contains five buttons, an infrared signal transmitter, and a compartment for batteries.
Simple and effective solution maintaining the necessary microclimate indoors is the installation of a thermal curtain. It is a special device that provides a directed flow of heated air, thereby preventing the influence of external factors. Thermal curtain KEV from Teplomash will not only allow you to maintain a given temperature regime, but will also prevent the penetration of dust and bacteria from the outside, eliminate changes in humidity, and so on.
Applications and advantages of thermal curtains
Thermal curtains Teplomash KE They are widely used in residential and commercial premises. They are most effective in places where it is necessary to maintain a given temperature and provide easy access. In addition, when doors or windows are opened frequently, they can reduce heat loss and reduce energy costs.
Special devices can be installed:
- in offices;
- V residential buildings;
- in warehouses;
- in stores;
- in shopping and entertainment centers;
- in garages and service stations;
- in production workshops and other places.
The high demand for devices is due to the fact that they have many advantages:
- reduce energy costs;
- easily maintain the required microclimate (temperature, humidity);
- easy to install;
- easy to maintain;
- prevent drafts.
Another advantage is the ability to delimit zones without installing doors or gates. Employees of production workshops, warehouse workers and other enterprises will be able to appreciate this advantage.
Wide range
Air-thermal curtain KEV- a sought-after product on the market. In this regard, the manufacturer produces various models this climate control equipment. They may differ in the following parameters:
- type (can be powered by electricity, hot water or other heat sources);
- productivity;
- technical characteristics;
- sizes;
- type of installation and so on.
When choosing, you should take into account many different factors, ranging from the size of the door or window opening to weather conditions and the purpose of the room. If you want to purchase thermal curtain, but don’t know which model to choose, contact our staff for help. We calculate and select the most best option who will easily cope with the assigned tasks.
Advantageous purchase of a thermal curtain
If you need a thermal curtain KEV, prices depends on design features And technical characteristics. In any case, the purchase of the device will fully pay for itself in a fairly short period of time due to energy savings.
Among the wide range in our store, you can choose a model for any purpose - domestic and commercial. Creating a microclimate in a store, warehouse, office or other room is not difficult at all. Contact our staff and place an order for the purchase of a thermal curtain with delivery.
The KEV thermal curtain helps preserve the microclimate of office, retail, warehouse, service or industrial sites. And according to the manufacturer, KEV climate control units will save not only the microclimate, but also the wallet of the owner of an office, warehouse or workshop. After all, thermal curtains of this brand consume electricity much more efficiently than devices created by competing companies.
How does the KEV air heat curtain work?
Preservation of the climate of the room protected by the curtain is carried out due to the generation of an air “barrier” - a stream of warm air blown from the nozzle of the climate control unit. Such a “barrier” blocks a door, gate or window opening, preventing contact between the external environment and the heated room. That is, cold air does not come into contact with the microclimate of the office, warehouse or workshop.
As a result, the temperature inside the protected room is equalized, the humidity level is stabilized, and heating costs are reduced. In addition, the air barrier cuts out dust and exhaust gases, prevents the penetration of insects and partially retains odors.
How do KEV electric heat curtains work?
Climate control units of this type are designed based on the diagram thermal convector. That is, the main structural elements of the curtain are the body, the heating element and the turbine driven by an electric motor.
A turbine and a heating element are located inside the housing, and the engine is mounted on the side (or bottom/top) side. The design of the housing and the layout of the internal and external components is determined by the installation diagram of the curtain, which can be hung above the opening (horizontal version) or installed on the wall or on the floor, on the side of the gate, door or window (vertical installation). In addition, depending on the installation scheme, a nozzle is installed on the bottom or side edge of the body - a narrow slit through which air is blown warm air. Positioning of the air curtain jet is carried out using external pads mounted on the housing nozzle.
As heating element curtains use tubular electric heaters or radiators connected to a water or steam heating. Moreover, thermal curtains with electric heaters are easy to install, but expensive to operate. But “water” or “steam” curtains are famous for their cheap operation, but will require professional installation, with possible restructuring of the heating system.
The thermal curtain turbine is designed according to the type radial fan. Its dimensions, as well as the characteristics of the engine, are selected based on the performance (the volume of air mass pumped per hour) and the thermal power of the air conditioning unit.
How to choose a curtain?
As a rule, curtains are selected according to the dimensions of the protected opening. Moreover, the geometry of gates, doors or windows must correspond and performance characteristics(thermal power and performance) of the air conditioning unit and its dimensions. After all, the curtain still needs to be mounted.
Therefore, the installation body must fit into the dimensions of the ceiling or the distance from the edge of the opening to the wall. And the performance characteristics must correspond to the area of the gate, door or window protected by the curtain.
Moreover, in order not to immerse our readers in the intricacies of engineering calculations that determine the identity of power and heat losses, we recommend paying attention to the data specified in the thermal curtain passport. After all, most manufacturers indicate the maximum dimensions of the opening that the curtain being sold will protect.
That's why best criterion choice is the passport of the thermal curtain.
Assortment of industrial thermal curtains of the KEV brand
Not the entire assortment of the KEV brand can be included in the segment of industrial climate control equipment. Only climate control equipment with an installation height of 3 meters or more, powered by a three-phase (industrial) power supply, can claim this “title”. Only some models of the Teplomash company fit these criteria, namely:
- Thermal curtain Teplomash KEV-12P3041E . This installation generates up to 12 kW of thermal power, providing a productivity of up to 3000 m3/hour. The installation diagram of this model is horizontal, with an installation height of up to 3.5 meters. However, vertical installation is also possible, when using KEV-12P3041E a 2-meter opening is blocked. The curtain can only be powered from three-phase network(380-400V). And among other advantages, it should be noted the possibility remote control this model, the dual-circuit structure of the heating element, which allows you to switch between 12 and 6 kW of thermal power, and the ability to work only on blowing, without heating. In short, KEV-12P3041E is a highly productive and economically profitable option thermal curtain. The price of this model is 18-25 thousand rubles.
- . This installation is mounted only in a horizontal position, covering an opening up to 3.5 meters high. Moreover, the KEV-9P2020E electric heat generator facilitates the installation and maintenance process to a level that requires minimum qualifications of performers. However, ease of installation does not detract from the performance characteristics of this model. The Teplomash KEV-9P2020E curtain generates 4.5-9 kW (at one and two stages of the heating circuit), pumping up to 1.5 thousand cubic meters of air per hour. Another plus of this model is its water resistance. Therefore, the KEV-9P2020E curtain can be installed not only in a warehouse, but also in a car wash. The cost of this curtain is 13-18 thousand rubles.
- Thermal curtain Teplomash KEV-6P2221E . This model can be connected to both a household network and an industrial line. However, the height of the opening protected by this curtain is only 2.5 m. Therefore, the KEV-6P2221E model should be classified only as a “semi-professional” segment of the Teplomash company’s product range. However, the power of this installation is 6 kW, and the productivity is 1.6 thousand m3/hour. That is, for 12-19 thousand rubles you can purchase a curtain with quite “industrial” performance characteristics.
Teplomash plant - leading Russian manufacturer air-thermal curtains KEV. Teplomash produces air curtains with thermal power from 1.5 to 130 kW.
You can buy a thermal curtain in several ways:
Mixing-type thermal air curtains heat cold air at the entrances of clinics, hospitals, schools, hotels, shops, cafes, restaurants, theaters, cultural and recreation centers, business centers, sports complexes. IN summer time An air curtain with damper protection protects the air-conditioned room from the penetration of warm outside air.
Industrial thermal curtains air flow cover gates (shielding protection) from 3 to 20 meters high in warehouses, industrial buildings, hangars, repair depots, garages.
Electric thermal curtain with IP54 is most often used to protect car wash gates. The most economical water heat curtain. If gas is supplied to the gate, then it is important to use a Teplomash gas thermal curtain.
Equipment
Each Teplomash thermal curtain is equipped with a thermostat and a wireless control panel.
In the compact electric curtains of the 100 series, up to 805 mm long, the brackets and controls are located on the body.
The control elements of the IP54 air curtain are selected separately by the designer.
Thermal curtains by purpose
The type of equipment must be selected in accordance with the specifics of the facility. These can be commercial, industrial, interior curtains.
Installation of thermal curtains
- Horizontal installation. The thermal curtain is attached to the ceiling or wall using fastening rods or brackets. The structure is located directly above the doorway. Closest possible location to front door will provide more reliable protection.
- Vertical installation. They are attached to the side of the opening (on one side or both sides). All models starting from the 200 series can be mounted vertically. Thermal curtains series 600 Column are mounted only vertically.
- Built-in curtains (ceiling curtains). Their design implies the presence of a module air-thermal curtain and special decorative panel. The main element hides suspended ceiling, which provides aesthetic appearance equipment.
